巜疯狂的少妇4做爰,国产精品成人国产乱,中文字幕在线观看亚洲日韩,亚洲精品成AV人片天堂无码,青青青在线视频国产,国产日韩成人内射视频,日出水了特别黄的视频,年轻的妺妺伦理HD中文,被部长玩的漂亮人妻,又硬又粗进去爽A片免费

航空翻譯_飛行翻譯_民航翻譯_藍天飛行翻譯公司

當前位置: 主頁 > 直升機 > 直升機資料 >

直升機飛行員手冊 直升機操作手冊 The Helicopter Pilot’s Handbook

時間:2011-04-05 11:37來源:藍天飛行翻譯 作者:航空 點擊:

To view this page ensure that Adobe Flash Player version 9.0.124 or greater is installed.


Check the manual and electrical releases, and don’t accept the fact that the solenoid clicks as evidence of it working. If there’s no-one else around, put a rope in and pull on it when you operate the mechanism. After you operate the manual release, check that the Bowden cable between the hook and the body of the helicopter doesn’t bind and stop the hook from rearming. All witness marks should be aligned on the knurled knob or lever and the hook body, make sure the hook moves over its full range of travel and that the bungee cord keeps it tight against the bottom of the fuselage, so you don’t land on a vertically extended hook, which may get snagged. Garbage on the landing site has been known to pull the manual release enough to allow the load to work itself free.
Condition of sling equipment
Because of the direct connection to the aircraft and the potential for damage, it should only be used on helicopter operations, and any worn or frayed items should be discarded (you’re generally allowed up to 10 randomly distributed frayed wires on a steel sling, or 5 in one strand). Nylon deteriorates when exposed to petroleum, and wire rope rusts and doesn’t like being mistreated, so protect them from moisture and heat, and inspect them regularly. Cables without their internal grease will snap readily. The maximum length for nylon or poly rope should be 6 feet.

There must be an eye in each end of a sling, preferably reinforced with steel, to protect the rope, and the shackle that goes inside the eye must be the right size for the hook, otherwise it may come out by itself, or not come out when it’s supposed to (as a guide, the shackle pin should be the same thickness as the rope – DON’T use a bolt instead; it will bend). Using a swivel will stop the load from spinning and unravelling the line. That is, you put the swivel in the hook, then attach the load to the swivel (which, by the way, has a thrust bearing in it). When using a screw-pin shackle (clevis):

with a rope of whatever description, don’t have the shackle downwards (as shown above), because the rope will slide from side to side and have a tendency to open the legs (if it rolls fore and aft, it will also undo the pin). Rather, place the screw-pin in the helicopter hook, padding the empty space either side with washers or similar, and use it upside down.
Chokers, technically, are lanyards that hold loads with a slipping noose which tightens under tension – the harder the pull, the tighter the grip. Use chokers at the end of a line rather than by themselves so that, if they break, they are kept away from the blades by the line (this also helps prevent collective bounce—see below). Be aware that a choker has 25% less safe working load because of the bend in the rope at the noose. The sharper the bend is, the less the SWL will be.
Long lines (see below) have an electrically operated hook at the end, which really makes them an extended hook, so there will be an electrical cable for the release mechanism, which should be carefully looked after; that is, the line and cable must be detached properly by ground crew, otherwise you will strip the cables, which won’t impress the engineers. If the insulation comes off, you may also get a short circuit. Lines made of Spectron or Kevlar are strong, but light, so will trail after you more than a steel line, hence the maximum external load speed. These lines also get longer when new, so, if you can’t pre-stretch them, allow a good length of extra electrical cable.

直升機翻譯 www.muluu.cn
本文鏈接地址:直升機飛行員手冊 直升機操作手冊 The Helicopter Pilot’s Handbook